2021-02-15
  * version has been upgraded to 2.0.2
  * gui 2 and all firmware 2 have been updated
  * add invert flag on onboard i/o form
  * change gui status bar for set digital message from 0/1 to on/off (since may be inverted)
  * add sensor warmup and alarm i/o to onboard i/o form
  * digital output is now open collector for sat140 (always was open collector for idp/st terminals)
  * port table entries are now created automatically for satscada 2
  * increase max callout count to 8640 per day (to permit 10 second intervals)
  * sat140 apn can be set over-the-air rather than using cloudgate web gui
  * proxy server and proxy client support LEO and WAN
  * dashboard supports LEO and WAN
  * proxy server has a monitor/restart to remedy google networking issues
  * ascii terminal upgraded for all satscada 2 terminals
  * virtual serial fixed so works via sat as well as cell/wan
  * added subvariant support for idp terminals that have multiple hardware types
  * added sat120 st9100 variant support
  * added sensor warmup
  * added alarm I/O
  * sat140 new features
    - option 2.96.0 firmware
    - application watchdog
    - gps port (left hand port)
    - WAN for dual ethernet sat140
    - modbus interbyte delay added to gui
    - bandwidth monitor
    - ftp client
    - grab serial
	- added system reboot to sat proxy task
	- digital output is open collector by default
  * added latest skywave ODT
  * gui does not flip forms when config is read, stays on same form