User Tools

Site Tools


radio

Radio

Used to set radio mode related parameters.

Radio

Site NameDescriptor for site.
RIO Network Type Sets the network type for the radio port. TELEMETRY: The RIO will transmit and accept broadcast messages from other RIOs containing IO module status. TRANSPARENT: The RIO will operate as a transparent radio. All RIOs in the network will require this parameter to be set the same.
Telemetry/Output Port Select which Port the RIO is to use for transmitting telemetry messages.
Radio Module Type None if Radio not used or SX900 for 900 Mhz
Radio Mode Specifies the operating mode of the radio module. PEER: Standard operating mode. REPEATER: Repeater
Transmit Power Sets the transmit power of the radio.
RF Bandwidth Sets the over the air rate. All RIOs in the network will require this parameter to be set the same.
Frequency Group Sets the physical RF channel selection. All RIOs in the network will require this parameter to be set the same.
Hop PatternSets the channel number used for transmitting and receiving data between RF modules. All RIOs in the network will require this parameter to be set the same
Network ID Network identifier. All RIOs in the network will require this parameter to be set the same.
Multi Transmit CountSets the number of times a message will be repeated. This can improve reliability at the expense of throughput.
Network HopsSets the maximum number of hops a message can travel.
Enable Encryption Enable 256bit AES Encryption on the radio module.
Encryption PhraseSet phrase used in encryption. All RIOs in the network will require the same phrase.
radio.txt · Last modified: 2018/10/05 08:21 by ahilchie