Used to set radio mode related parameters.
Site Name | Descriptor for site. |
RIO Network Type | Sets the network type for the radio port. TELEMETRY: The RIO will transmit and accept broadcast messages from other RIOs containing IO module status. TRANSPARENT: The RIO will operate as a transparent radio. All RIOs in the network will require this parameter to be set the same. |
Telemetry/Output Port | Select which Port the RIO is to use for transmitting telemetry messages. |
Radio Module Type | None if Radio not used or SX900 for 900 Mhz |
Radio Mode | Specifies the operating mode of the radio module. PEER: Standard operating mode. REPEATER: Repeater |
Transmit Power | Sets the transmit power of the radio. |
RF Bandwidth | Sets the over the air rate. All RIOs in the network will require this parameter to be set the same. |
Frequency Group | Sets the physical RF channel selection. All RIOs in the network will require this parameter to be set the same. |
Hop Pattern | Sets the channel number used for transmitting and receiving data between RF modules. All RIOs in the network will require this parameter to be set the same |
Network ID | Network identifier. All RIOs in the network will require this parameter to be set the same. |
Multi Transmit Count | Sets the number of times a message will be repeated. This can improve reliability at the expense of throughput. |
Network Hops | Sets the maximum number of hops a message can travel. |
Enable Encryption | Enable 256bit AES Encryption on the radio module. |
Encryption Phrase | Set phrase used in encryption. All RIOs in the network will require the same phrase. |